|
The PPS-150 is a fence-top mounted intrusion detector, consisting of a set of 8 transmitter/receiver pairs, each with a maximum range of 50 meters. If necessary, the amount of pairs can be pre-ordered accordingly. | | | | | | | |  |  | | | | | | | | | PPS-150 | Detection zone pattern | Upon detection of an intrusion the PPS-150 outputs an alarm through a normally closed dry relay contact, by opening it. The pps-150 is unique in its ability to operate both as a complete system and as individual pairs. Multiple zones allow for higher precision in locating the intrusion and for the conservation of power as all detector pairs use the same 12volt DC external power supply.
Technical specifications Maximum detection zone length:
| 30x7=210m (690ft)
| | Minimum detection zone length: | 3m (10ft) for one section
| Detection zone width:
| 1m (3ft) | | Ready for operation after power up: | 30 sec | | Ready for operation after alarm: | 10 sec | | Temperature range: | -40° to +65°C (-40° to +149°F) | | Relative air humidity: | up to 100% at +25°C (+77°F) | | Output signal type: | NC contact opening for 2 seconds | | Signal relay parameters: | 72 V, 0.1 A | | Detector testing: | Can be done remotely | | Detector power requirement: | 15-30V DC | | Detector power consumption: | 30 mA @ 24 V DC 55 mA @ 12 V DC | | Transmitter / Receiver Size (without bracket): | Ø48x259mm (Ø1.88"x10.2") | | Weight: | 6kg (13.24lbs) |
|